Ferrite Bead For Headset Wire – QuantaDefence

GET AN AIR TUBE HEADSET

WireGuards are the ideal add-on accessory to reduce RF on any headset using a wired design. Even Air-tube headsets have a wire “often in contact with your body,” and a WireGuard prevents the wire from acting as an effective high-frequency antenna!

The WireGuard suppresses radiation transferred up the headset wire to the earpiece without affecting sound quality.

Important Ferrite News: Feb 13, 2014, Ferrite Beads Reduce Cell Phone Radiation Health Hazards From Wired Hands-free Headsets

[pullquote]Ferrites are used in many consumer electronics to prevent interference from disruptive electromagnetic radiation, but they have limitations. Although ferrites allow low-frequency energy to pass, ferrites have a frequency band they are designed to block. Therefore, depending on the ferrite’s core composition, a ferrite’s performance diminishes at frequencies higher than it is rated.

While even the newest LTE phones may exceed ferrite beads limitations, that same LTE 4G phone is also designed to operate on network frequencies where the ferrite is effective.   RF Safe concludes a ferrite bead’s usefulness should be likened to an analogy of sunblock.  It reduces exposure to a spectrum of radiation, but by no means will it block all the harmful waves/rays. [/pullquote]

For this reason, RF Safe suggests the most prudent avoidance of RF radiation to use an air-tube headset. That way, no wires are reaching a user’s head, and the ferrite is added protection where the wire comes in contact with a user’s torso.

“RF Safe’s ferrite bead is especially important for women that are pregnant or trying to have children when the headset wire is unshielded and comes in contact with the body,” says Coates.

The wire guard is a reusable radiation suppression clamp-on device similar to a clamshell. This device clamps over the headset wire above the plug that is inserted into the phone. It incorporates a ferrous composition-based material that interacts directly with the high-frequency energy and suppresses it effectively while allowing the voice signal to pass through to the earpiece unimpeded. The housing is a black composite manufactured using nylon resins. IT FITS ANY HEADSET!

How it works! The effect of magnetic material on a conductor.

Current flowing through a conductor creates a magnetic field around it. Transfer of energy between the current and the magnetic field is effected through the “inductance” of the conductor – for a straight wire, the self-inductance is typically 20nH per inch. Thus, placing a magnetically permeable material around the conductor increases the flux density for given field strength and increases inductance.

Using a cell phone with a hands-free headset that is NOT shielded will dramatically increase rf radiation exposure to DNA within vital organs. All studies have proven the likely hood that microwave radiation from a cell phone handset is hazardous. WireGuards help prevent the possible 300% increase in RF Exposure to the brain that can happen when not using a shielded headset!

One other major concern of using a headset for hands-free usage is where the phone itself is placed. When hands-free use requires the phone to be held near your body, proper Body Shielding must be used! (Pocket Shields & Belt Clip Shields)

1. Position headset wire just above the plug into either ‘V’ Channel.

2. Close one side over the other, verifying the wire passes through the opening on both sides and the side tabs lock.

3. To transfer to another headset, carefully open the side tabs using a small screwdriver.